How to independently align window slopes without a corner
To align the window slopes, the following tools will be needed: level, rule, grater, a large and small spatula, roulette, punch, new settlers, nails-shurups, a 90 degree square. First of all, at an angle of 90 degrees from the window from below and above, draw straight lines. If we want direct slopes, then we leave it, and if we want to expand the slopes a little, then add a couple of centimeters to the lines drawn.
For example: if the window is 100 centimeters, then we make slopes about 106-110 centimeters. Further along the drawn lines, we set the rule in the level vertically, after which we fix it, making the through holes with a punch directly in the rule and wall. We fasten the rule to the wall with nails-shurups. We also do it on the other side. Thus, the rule plays the role of a lighthouse. Then we make a solution of putty and begin to work with it. We apply it evenly, and align it with a spatula according to the established rules-beaces.
After applying the solution, we wait until it does not dry out completely. Then we carefully remove the established rules and see the perfect angle. At the same time, there is no need to buy special corners. We make the upper slope as well as the side, from the right corner we add 2-3 centimeters and draw two lines on the left and right slopes. According to these lines and level, we horizontally set the rule and fasten it to the wall. We do everything too as with lateral slopes. Then apply the solution, and again align with a spatula. We are waiting for complete drying, and remove the rule. After the work done, take the grater and grind the applied solution. Well, that’s all, it remains only to paint with water -based paint.