If the wallpaper is pasted not only the surface of the walls, but the ceiling then you need to start the past. After marking the first strip of your wallpaper, begin to glue them deep into the room. On the working countertop, the canvas that you prepared must be covered with an uniform and non -thick layer of glue, carefully observing that this glue does not hit the edges of the wallpaper.
Have long been looking for a good company that has been conducting high -quality cottage decoration? We advise you to visit this Kapmaster site and use the finish there.
After that, it is advisable to lay your canvas and leave for four minutes so that it is carefully saturated. After that, take your folded wallpaper, go up to the surface with which you plan to work and carefully dissolve them slowly to the ceiling.
Then equalize the edges and remove all kinds of bubbles with a dense clean rag or a special rubberized roller from the center and to the edges. The second and next sheets of wallpaper need to be glued over. That is, so that the edges of the already sticker piece of wallpaper are cut with subsequent canvases, but, most importantly, no more than 5 mm. A strip of wallpaper, which will be glued in the place where the wire will pass under the light bulb, you need to carefully cut the hole of the desired size.
It is better to paste the ceiling with wallpaper in a bet so that one puts and presses the wallpaper, and the second holds, for example, a mop, the remaining undelipated piece of strip upstairs