Parquet cycles and its rules
In any room, the floor is an indispensable and important attribute, which also lends itself to maximum loads, which makes it possible to quickly lose its appearance and requires repair. Well, the most difficult type of floor restoration is the parquet cyclist. Although even this procedure can be carried out with joy if you have all the necessary tools and you know all the stages of this process. Grinding itself is often carried out by a special grinding machine. But before the grinding starts, all visible defects must be eliminated.
But let’s figure out in more detail what tools are needed to perform this process.
Firstly, this is a grinding type grinding machine, although of course it is quite expensive, but you can always take it to pay about $ 20 per day, because for a day you will have time to do all the work that is connected with its use.
The next important tool is the equipment intended for grinding angles, which is called boots, although of course, these works were carried out using a simple grinder, but the boots are more accurate and modern grinding method.
And of course you need hand -made sandpaper, scissors for this paper and vacuum cleaner.
The grinding process itself is divided into the following stages:- preparation, which includes rearrangement of furniture, release of the entire floor surface, checking the parquet for drop-down strips and removing skirting boards.
– Individual protection – you simply have to put on a respirator’s mask before you start a parquet cycle.
– rough cycle – produced by large nozzles of sandpaper, as it cleans the varnish and removes the wood layer of about 5 mm.- grinding.- Processing of hard -to -reach surfaces.
Well, after the completion of all cycles, the parquet is opened with varnish. And believe me that in case of properly and efficiently work, your parquet will gain its former beauty even after many years of use.