Construction councils
It is necessary to prepare the surface of the wall before proceeding with the actual glue itself. It should be even, cleaned of dirt, dust and smooth. To check the flat wall, a special rail is applied to the wall. If the irregularity is no more than half a centimeter of nothing terrible. When deviated more than this indicator, the wall should be leveled using solutions or plaster. Pre -processing the wall with a primer for disinfecting, as well as for the best bunch of materials and strengthening the processed surface. If it is necessary to apply the second layer of plaster to wait for the first layer to dry. account
Starting work on laying tiles, porcelain tiles, you should first make the correct calculation of the required number of tiles. Purchase by about 10-15% of tiles more. In the process of transportation, laying and cutting of tiles, part of it can be made unusable. Start laying tiles from the lower corner. An adhesive solution is applied to the surface with the smooth side of the trowel, then the same side is evenly distributed over the entire glued surface and the back of the trowel is applied by grooves. This is done in order to ensure the better gluing of materials. The tile is pressed against the wall with the entire surface and to the rail edges. Strongly should not be crushed on the tile. The same is repeated with other tiles. For uniform gluing of tiles, the masters adopted the use of special crosses – they allow you to maintain a clear line of the picture, which greatly simplifies your work. The last step in working with tiles is the grout of the seams. It should only be carried out after the glue layer has finally dried. All crosses are removed. The seams are wiped diagonally in relation to the tile. After the final drying of the grout, the tile is wiped with a dry rag. Then, if dirt is detected, wipe with a damp (not wet) sponge. And again wipes a dry rag. That’s actually the whole process.