You can perform the well yourself, while you can save a lot. First you need to prepare all suitable and necessary materials. As a rule, you need to have corrugated or ordinary pipes, the diameter of which should be 5-7 centimeters, their length should be 1.5-2 meters. Pipes will need no more than 8. At the ends of these pipes, it is necessary to perform threads and purchase bushings for them. So the pipes can be interconnected. It will also be necessary to purchase a steel rod, it will require several pieces of 2-2.5 meters long and 20-30 millimeters in diameter.
Pieces of these rods must also be provided with carvings and bushings. You will also need a steel cone. The cone should have a diameter larger. By the end of the cone, you need to weld a piece of the pipe in which longitudinal seams are cut. These cracks need to be wrapped with a net. Thus, a simple filter appeared.
A pipe with a cone must be driven using steel rods. They need to be lowered inside the pipe. It is necessary to sharply hit the cone, thus, the cone will clog in the ground. When it scores, you need to wrap the threaded part of the Pacley cone, which is saturated with paint. Now it remains to get a coupling and the next piece of the pipe.
When the rod becomes short, it is growing a new piece. Pipes are clogged to a depth of about 3 to 6 meters. Thus, it is necessary to get to the aquifer. When this happened, you need to dial a bucket of water and pour it into the pipe. If the water does not go further, then you need to continue to drive the pipe. It is necessary to ensure that the water leaves quickly.
After that, you need to check the quality of the water, if it is bad, then it is necessary to carry out the pipe further. Until the water has the necessary quality. Such a well will not supply a large amount of water in a short time, but it is quite suitable for use.